Tuesday Tech Talk: Design for Manufacturing Webinar Series
When designing a new electronic device (should it be an IC or a PCB) one system critical question that comes to mind is: can it be manufactured? It is clear that designing without being able to fabricate is not an option. Once the question is answered, it is then mandatory to design with manufacturing in mind. Maximizing yield and avoiding costly design re-spins are 2 issues which strongly influence ROI metrics for electronic design. This is true for both Integrated Circuits and Printed Circuits Boards domains.
Curing Reliability Issues at the IC Design Stage
On-demand Web Seminar: This presentation offers an introduction to these problems and explains how advanced EDA tools can help integrate the reliability prediction capability in the design cycle itself.
IP Scoring Using TSMC DFM Kits
On-demand Web Seminar: This talk proposes a method of scoring IP from cell to block level for DFM quality which provides a basis for building high DFM quality into your SoC and gaining maximum yield potential.
Signoff Physical Verification in the Place and Route Flow
On-demand Web Seminar: This presentation delves into the sources of manufacturing variability, their effect on the traditional design and verification flows, and the emerging EDA solutions that fully integrate the design and...